|
|||||||
| Ostali muzički instrumenti i studijska oprema Pregled i karakteristike ostalih instrumenata, gitara, mikrofona, preampa, rack efekata, mikseta, patch bays, modula, semplera.... Diskutujte na ovom mestu |
 |
|
|
Thread Tools | Display Modes |
|
|
06-08-2007, 09:46 PM
|
#1 |
|
MCI Master
Join Date: Aug 2006
Posts: 1,509
|
Re: Malo O Mci Desku ..pitanje Za El.strucnjake!!!
e imam jos jedan info samo da ga najdem
|
|
|
|
06-08-2007, 09:50 PM
|
#2 |
|
MCI Master
Join Date: Aug 2006
Posts: 1,509
|
Re: Malo O Mci Desku ..pitanje Za El.strucnjake!!!
OVO IMAM O STELANJU NOVOG MCI VCA MC 202 ali nije stelanje kao kod orginalnog PCBA...bar mislim
you'll need a 10K pot act as the "Fader" Install the 4 resistors as noted above (R1010, R1011, R1003, R1006) On the MCI Board: Pin 1 is the input for the 1K tone from a low distortion oscillator Pin 2 is +15vdc from bench power supply Pin 3 is to the wiper and one outside terminal of the 10K pot (tie together) Pin 4 is ground: tie the other terminal of the pot here along with your audio grounds Pin 5 is output to distortion analyzer input Pin 6 is -15vdc Adjustment procedure: Place VCA modules on fixture powered by +/- 15vdc Set ocilliator output to 1K @0dBv and input to Pin 1 Adjust the 10k pot so that the module provides 0dB of gain (unity) This voltage, measured at the 10K pots wiper should be around -51vdc Adkust the pot on the VCA module for minimum THD (distortion) The THD should be around .007% using a 30Khz cutoff. Make the resistor changes on the other MCI VCA cards and Install modules. |
|
|
|
|
06-08-2007, 09:52 PM
|
#3 |
|
MCI Master
Join Date: Aug 2006
Posts: 1,509
|
Re: Malo O Mci Desku ..pitanje Za El.strucnjake!!!
ako se ne varam mogu kao signal koristiti MCI jev OSCILLATOR na 1khz?????
to bi bilo super....... JER SAM GA FINO SREDIO I REKAPIRAO!!!!!! |
|
|
|
|
06-08-2007, 10:31 PM
|
#4 |
|
Moderator
Join Date: Sep 2005
Location: Beograd
Posts: 6,200
|
Re: Malo O Mci Desku ..pitanje Za El.strucnjake!!!
Prvo, imas RME? Ok.. da li on ima balansirane (analogne) ulaze i izlaze? (nemam RME pa pitam)
Drugo... u kakvoj ti je masini RME? PC ili MAC? pozdrav bogi
__________________
Email: boggy@myroom-acoustics.com --"We can never see past the choices we don't understand." (Oracle, The Matrix Reloaded) |
|
|
|
|
06-08-2007, 10:41 PM
|
#5 |
|
MCI Master
Join Date: Aug 2006
Posts: 1,509
|
Re: Malo O Mci Desku ..pitanje Za El.strucnjake!!!
RME NEMA BAL in out ..IMA ALPHA LINK ALI MISLIM DA CU POSUDIT RME MULTIFACE ZA OVO....
ZA SAD JE SVE U MACU ALI ZA 30 minuta sve moze bit u PCu 
|
|
|
|
|
06-08-2007, 10:59 PM
|
#6 |
|
Moderator
Join Date: Sep 2005
Location: Beograd
Posts: 6,200
|
Re: Malo O Mci Desku ..pitanje Za El.strucnjake!!!
Ajd da ne gnjavim...
Za ovo ti treba pristojna profesionalna karta sa balansiranim stereo in i stereo out... koja moze 24bit na 48 i 96kHz. Strasno bi olaksalo posao ako bi ta karta bila u PC pod Windows XP. pozdrav bogi p.s. gde pobeze?
__________________
Email: boggy@myroom-acoustics.com --"We can never see past the choices we don't understand." (Oracle, The Matrix Reloaded) |
|
|
|
|
06-08-2007, 11:07 PM
|
#7 |
|
MCI Master
Join Date: Aug 2006
Posts: 1,509
|
Re: Malo O Mci Desku ..pitanje Za El.strucnjake!!!
recimo da to imam od sutra podne!!!
PC XP sp1 i MULTIFACE RME...96k 24 BITA!!!!!!!!! balansirani i nebalansirani I/O po zelji  a Software .....??? idem gledat na net |
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| malo glupo pitanjeali samo malo | alavuk | Sintesajzeri, Klavijature i Elektronika | 11 | 25-01-2008 10:12 AM |
| malo glupo pitanje,ali... | dlukace | Ostali muzički instrumenti i studijska oprema | 14 | 19-10-2007 08:52 AM |
All times are GMT +1. The time now is 06:29 AM.