Malo O Mci Desku ..pitanje Za El.strucnjake!!!

[roginator]

inace SPARROW izgleda OPAKO!!!!!

koje bi mi pojacalo preporucio za NS 10m??? ono vase...volio bih to cut!!!!!

[boggy]

Originally Posted by roginator

inace SPARROW izgleda OPAKO!!!!!

Hvala!

Originally Posted by roginator

koje bi mi pojacalo preporucio za NS 10m??? ono vase...

Da.

Originally Posted by roginator

volio bih to cut!!!!!

Ajd... kad god hoces... gde god hoces i kako god hoces
Pa ti sad izaberi

pozdrav

bogi

[roginator]

evo vrijeme za VCA...uh jos malo i gotovo


evo Boggy

pin 1 signal input
pin 2 +15v
pin 3 control (from fader)
pin 4 ground
pin 5 signal out
pin 6 -15v

na mojim PCB mosulima je 5534 (ne 741!!!)

R1008 je calibration trim
VCA = DBX 202c

Evo sto mi je rekao LARRY LAMORAY
jedan od vodecih Ljudi MCI i osoba koja je sastavljala MCI pultove u EX Jugi

The only thing I remember - vaguely - about the VCA's is that they were

DBX-201s or -202s (I think), and seem to recall that they needed to be
optimized at the "0" Fader setting (sweet spot) for +4 in and out of
the
module

ajde sad...
a: dali da to stelam u pultu ili van njega....
b: kako
c: kojim softwareom:
d: koja procedura....

hebiga nisam nikad to radio (jumfer) pa mi treba malo inputa

[roginator]

e imam jos jedan info samo da ga najdem

[roginator]

OVO IMAM O STELANJU NOVOG MCI VCA MC 202 ali nije stelanje kao kod orginalnog PCBA...bar mislim

you'll need a 10K pot act as the "Fader"

Install the 4 resistors as noted above (R1010, R1011, R1003, R1006)

On the MCI Board:

Pin 1 is the input for the 1K tone from a low distortion oscillator
Pin 2 is +15vdc from bench power supply
Pin 3 is to the wiper and one outside terminal of the 10K pot (tie
together)
Pin 4 is ground: tie the other terminal of the pot here along with your
audio grounds
Pin 5 is output to distortion analyzer input
Pin 6 is -15vdc

Adjustment procedure:

Place VCA modules on fixture powered by +/- 15vdc
Set ocilliator output to 1K @0dBv and input to Pin 1
Adjust the 10k pot so that the module provides 0dB of gain (unity)
This voltage, measured at the 10K pots wiper should be around -51vdc
Adkust the pot on the VCA module for minimum THD (distortion)
The THD should be around .007% using a 30Khz cutoff.
Make the resistor changes on the other MCI VCA cards and Install
modules.

[roginator]

ako se ne varam mogu kao signal koristiti MCI jev OSCILLATOR na 1khz?????

to bi bilo super.......

JER SAM GA FINO SREDIO I REKAPIRAO!!!!!!

[boggy]

Prvo, imas RME? Ok.. da li on ima balansirane (analogne) ulaze i izlaze? (nemam RME pa pitam)

Drugo... u kakvoj ti je masini RME? PC ili MAC?

pozdrav

bogi