evo vrijeme za VCA...uh jos malo i gotovo
evo Boggy
pin 1 signal input
pin 2 +15v
pin 3 control (from fader)
pin 4 ground
pin 5 signal out
pin 6 -15v
na mojim PCB mosulima je 5534 (ne 741!!!)
R1008 je calibration trim
VCA = DBX 202c
Evo sto mi je rekao LARRY LAMORAY
jedan od vodecih Ljudi MCI i osoba koja je sastavljala MCI pultove u EX Jugi
The only thing I remember - vaguely - about the VCA's is that they were
DBX-201s or -202s (I think), and seem to recall that they needed to be
optimized at the "0" Fader setting (sweet spot) for +4 in and out of
the
module
ajde sad...
a: dali da to stelam u pultu ili van njega....
b: kako
c: kojim softwareom:
d: koja procedura....
hebiga nisam nikad to radio (jumfer) pa mi treba malo inputa
