..Alesis M1 Active Mk2 zabluda?..

[boggy]

Originally Posted by lesha

evo specifikacija:

CROSSOVER SECTION

Crossover type: 4th-order, 24dB/octave Linkwitz-Riley @ 2000Hz
Input Impedance: 20kOhm balanced 10kOhm unbalanced
Low Frequency Filter: 4th order optimal Q high pass filter at 48Hz with +3 dB
equalization

AMPLIFIER SECTION

LOW FREQUENCY AMPLIFIER
Rated power output: 75 watts, 6 Ohm load
Distortion: <0.02% THD @ 30 watts/8 Ohm 20Hz-20kHz
Slew rate: 19V/?sec
Signal-to-Noise ratio: >110dB referenced to 60 watts @ 8 Ohm, ?A? weighted, 1kHz

HIGH FREQUENCY AMPLIFIER
Rated Power Output: 25 watts, 4 Ohm load
Distortion: 0.025% THD @ rated power
Slew rate: 9V/?sec
Signal-to-Noise ratio: >112dB @ rated output

ACOUSTIC SECTION

Free-Field Frequency Response: ?2dB, 50Hz to 20KHz
Lower Cutoff Frequency: 40Hz -10dB
Upper Cutoff Frequency: 23.5KHz ?10dB
Maximum Peak SPL per pair: = 118dB SPL @ 1m
Maximum short term SPL: 80Hz to 3.0KHz = 105dB SPL @ 1m

Nista o osetljivosti ulaza, valjda je +4dBu... kako si razbalansirao konekciju... presao sa nebalansiranog na balansirani ulaz?

Na kraju, ako nista ne uspemo.. ocepi ti njega do kraja i utisavaj na karti...

ili nadji neki master volume, mozda ti ne bi bio los neki di-box sa atenuacijom... ima li tako neceg da se kupi za male pare?

pozdrav

bogi