Pozdrav svima!!!
Dugo sam čitao forum i na?ao dosta korisnih odgovora na neka svoja pitanja, ali imam jedno koje ne mogu razrije?iti.
O čemu se radi...
Neko je negdje na internetu pomenuo da je spalio line out na pojačalu tako ?to mu je tonac pustio "phantom power" kroz kabl.
Namjeravam nabaviti Line 6 LD bass pojačalo koje ima balanced XLR output i za koji proizvođač ka?e:
Quote:
XLR Direct Out - This gives the sound man a
simulation of a mic'd cabinet that is model specific.
This is your Direct Out for recording or sending your
sound to a house sound system when you?re playing
live. This output utilize Line 6?s exclusive A.I.R.
processing which has made Line 6 products like POD
the undisputed standard for recording direct. The level
of this output is set via Channel Volume and has a
ground lift switch to lift the ground if your direct out
is causing a buzz in the sound/recording system you are
connected to. A bit of advice, many pro sound engineers
here at Line 6 have made the direct out experience
from this amp a beautiful one. Many sound engineers
prefer to take a Pre Amplifier Direct Signal via a Direct
Box. This is the de facto technique for getting basic
bass tone in the house PA. When playing a gig in a
club, ask the sound guy to consider using your direct
out for amp and cabinet tone - they will not be
disappointed!
|
Moje pitanje je, da li je svaki balanced XLR direct out po defaltu
imun na 48V fantom napon? Ili nije?
Da ne bih experimentisao, empirijskim metodama (probaj pa saznaj), kako bi se sve pona?alo kada bih izlaz iz pojačala povezao kratkim balanced-unbalanced XLR patchem na DI box (npr. Ultra DI100) i onda dalje bezbri?no prema mixu?
Hvala unaprijed!!!