Ajd Sad Problem Ovoooooliki
 

Ljudi imam problem tezak....Kada otvorim projekat koji sam radio u Nuendu, krene da ucitava plugin-ove itd i kad dodje do Battery 3-ojke muci se par sekundi i izadje mi plavi ekran i komp mi se resetuje...Probao sam reinstaliranjem baterije ali nista se ne desava, opet se resetuje...HELP!:banghead:

Re: Ajd Sad Problem Ovoooooliki
 

Ne znam koju verziju Battery 3 imas ali zadnja ti je 3.02 :)

Re: Ajd Sad Problem Ovoooooliki
 

Mislis da moze da dodje do problema zbog verzije?U svakom slucaju hvala:)I'll try!

Re: Ajd Sad Problem Ovoooooliki
 

Click Start > Control Panel (category view mode) > Performance and Maintenance > System > Advance tab > Settings button in Startup and Recovery section. Uncheck the box next to Automatically restart in the System Failure section. Click ok.


Resetuj se, a zatim uradi sve kao sto si radio, i kada ti izadje BSOD (plavi ekran), onda se komp nece resetovati vec ces moci da procitas koju gresku prijavljuje pa nam napisi ovde ...

Re: Ajd Sad Problem Ovoooooliki
 

Deinstaliraj batery i pokreni nuendo ako ti se i tad pojavi BSOD onda mozda i nije batery, mozda je drajver za karticu ili nesto trece.

Re: Ajd Sad Problem Ovoooooliki
 

koliko RAM-a imas?

Re: Ajd Sad Problem Ovoooooliki
 

To sam vec probao i Battery je kriv:)

Imam giga ram-a!


Ova je greska:

STOP: 0X0000008E (0XC0000005, 0XECE9A703, 0XB82EFC70, 0X00000000)

windrvNT.sys - Address ECE9A703 base at ECE99000, datestamp 4097405C

Re: Ajd Sad Problem Ovoooooliki
 

puko ti je registry sto za battery 3 i nije nesto novo

Re: Ajd Sad Problem Ovoooooliki
 

Alavuce, sta da radim brate?

Re: Ajd Sad Problem Ovoooooliki
 

Taj proces je zaduzen za windows file protection.
Probaj prvo da disejblujes WFP u registryju:

Disabling Windows File Protection


You may disable WFP by setting the value SFCDisable (REG_DWORD) in HKEY_LOCAL_MACHINE\ SOFTWARE\ Microsoft\ Windows NT\ CurrentVersion\ Winlogon. By default, SFCDisable is set to 0, which means WFP is active. Setting SFCDisable to 1 will disable WFP. Setting SFCDisable to 2 will disable WFP for the next system restart only (without a prompt to re-enable).

Important: You must have a kernel debugger attached to the system via null modem cable (for example:I386kd.exe or Windbg.exe) to use SFCDisable = 1 or SFCDisable = 2.

After WFP is disabled using the SFCDisable = 1 setting, the following message will appear after logon:

Warning! Windows File Protection is not active on this system. Would you like to enable Windows File Protection now? This will enable Windows File Protection until the next system restart. <Yes> <No>.

Clicking Yes will reactivate WFP until the next system restart. This message will appear at every successful logon until SFCDisable is set to 0.